12/17/2022 0 Comments Mastercraft belt sander manual![]() This step is very important, and you must take time and patience throughout this task. Step 4: Attach the Sandpaper onto the Clamp Also, remove or cut out any kind of additional sandpaper that might be sticking out of the sander base. Keep in mind that the sandpaper length should properly align with the sander length in a parallel form. In this step, position the smooth side of the paper towards the base of the machine. Take the sandpaper and place it on the sander base. Step 3: Use the Utility Scissorsįold the sandpaper first and then cut it with the utility scissors. Make sure you cut the sandpaper (lengthwise and widthwise) precisely so that the base of the sander can be covered properly. This is done to ensure that the sandpaper can attach the front and rear clamps, which you can find on top of the sander. Leave sufficient length of sandpaper so that it can cover the base of the sander at both ends in an upward direction. Adjust the machine properly so that you will get the chance to cut a large number of sandpapers from a single sheet. Take the sander and put it on top of the sandpaper. As different models come with different clamps, you must give it a check before you start placing the sandpaper. Gently hold the sander and check both the front and rear clamps to make sure they are in the right place. Below, you will find out the steps to put sandpaper on a sander easily. Step 4: Attach the Sandpaper onto the Clamp. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |